No, the technology does not change the chemical composition of the water in any way. It works purely on a physical basis, leaving the water completely safe.

Yes, although it may be a gradual process over a period of months. The way in which our technology prevents limescale from forming on pipe work also increases the solvicity of water - meaning that any limescale, which had already formed, will gradually dissolve. However, not all scale is limescale. Some scale cannot be dissolved and can only be removed by acid cleaning. Once a system is cleaned it is less likely to scale up again.

One main difference is the different power output per cubic millimetre. This simply means the industrial model like the Aquaklear P treats a larger volume of water than say the Aquaklear J62. Please seek advice from your local Hydropath expert who will provide you with the optimum solution.

Should any fault occur during the first three years of operation it will be replaced or repaired free of charge. – See also installation instructions.

No, the signal is a long wave radio signal on a frequency of 120-140KHz and conforms to European and International Directives including the Low Voltage Directive. Therefore sensitive electrical equipment such as pacemakers will not be affected.

Hydroflow does not change the chemical composition of the cold water supply. It works purely on a physical basis, leaving the water completely drinkable, and essential minerals that were present before are retained in the water, without any changes.

Yes, Hydropath have specifically designed a transformer power supply adapted to your national electrical system. Please seek advice for the correct power supply option for you.

As our range of electronic water conditioners treat a whole range of problems, it is important that you seek advice from a trained specialist in Hydropath technology. This way you will achieve optimum results from our technology.

HydroFLOW does not change the chemical composition of the water in any way. It works purely on a physical basis, leaving the water completely drinkable, and essential minerals are retained in the water, without any changes.

This all depends on the model you have. Firstly you must see that the light is on. With the domestic and small commercial models this will be a red light. With the large industrial units the PSU has a red and green light. This light not only shows the unit has power, but that the signal is propagating throughout the whole system. If the light is dimmed, it may be that the model is placed within a short circuit and cannot propagate throughout the system.

It depends on the application, and which model has been fitted. For example if it is an algae problem you will see a marked reduction, and you will radically reduce your chemical usage. For the consequences of limescale in the household you will no longer see limescale build-up. Check your showerheads and taps and you will notice for yourself. The optimum results depend on where you install the device, the integrates of the water source, and other factors. In any case you can consult with your local Hydropath expert.

No. Limescale contains minerals e.g. calcium that is good for teeth and bones. There is no direct connection between limescale and kidney stones, which are formed by other substances.

Limescale comes out with flow. Without Hydropath technology limescale will adhere to heat exchangers, internal pipes, shower heads, taps etc.

Yes the technology ensures the unique field is induced longitudinally directly into the water throughout the entire system regardless of the type of the pipe material. The signal is induced using solid-state ferrite technology

Hydroflow only uses a maximum power of 1.2 watts, when connected to the mains supply, through its 12v AC transformer. This very low power consumption means that it costs, in the UK, approximately just over £1 a year to run.
( This price, however depends on the electricity prices current at the time).

No. Our household products do not require any special treatment. The device operates by means of solid-state technology and has no moving parts, such that its operation is ensured for years without requiring maintenance.